Is It Any Good? LONGER RAY 5 10W Laser Cutter & Engraver. I assemble, setup and review.
How to build and assemble the LONGER RAY5 10W laser cutter and engraver. I show every step in close-up detail of how to assemble this laser. Watch the video: ▼ ASSEMBLY TIPS AND TRICKS There are a few tips to building it that we're not mentioned in the instructions. 1. The inside corner brackets. Don't tighten the screws right away. Loosely tighten both screws first, allowing the bracket to move to the right position. Then fully tighten both screws. 2. Belt tightening. Loosen
Fiber Laser Engraved Aluminum EVEREMAN Cubes
These deep engravings in aluminum were achieved by using multiple passes with the Fiber Laser engraver. The graphics etched into the 3 inch aluminum are for a metal cube series by the artist Evereman Evereman http://evereman.com/ #laser
