Is It Any Good? LONGER RAY 5 10W Laser Cutter & Engraver. I assemble, setup and review.
How to build and assemble the LONGER RAY5 10W laser cutter and engraver. I show every step in close-up detail of how to assemble this laser. Watch the video: ▼ ASSEMBLY TIPS AND TRICKS There are a few tips to building it that we're not mentioned in the instructions. 1. The inside corner brackets. Don't tighten the screws right away. Loosely tighten both screws first, allowing the bracket to move to the right position. Then fully tighten both screws. 2. Belt tightening. Loosen
Fiber Laser Engraved Aluminum EVEREMAN Cubes
These deep engravings in aluminum were achieved by using multiple passes with the Fiber Laser engraver. The graphics etched into the 3 inch aluminum are for a metal cube series by the artist Evereman Evereman http://evereman.com/ #laser
Laser Cutting Leather
Laser Cutting thin leather with the Epilog Zing 30W CO2 Laser Cutter. Settings are 100% Speed, ??% Power, ???Hz Frequency. These are for a customer in Marietta, Atlanta, GA.
Laser Cutting Felt and Fleece Fabric
Laser Cutting 2 layers of 1/16 inch thick Felt Fabric with the Epilog Zing 30W CO2 Laser Cutter. Settings are 100% Speed, 23% Power, 200Hz Frequency. These are pieces that will be sewn onto felt pillows by www.sushistyle.com from Atlanta, GA Laser Cutting 2 layers of Fleece Fabric using a 30W Epilog Zing CO2 laser. Settings are 100% Speed, 30% power, and 200Hz frequency. These are some of the pillows that she made previously from felt that we laser cut. Buy the pillows at
Laser Engraved Maple Cutting Boards
HotHead Studios in Decatur, GA wanted 100 custom cutting boards as Christmas gifts to send out to clients. We connected them with the furniture makers at www.theinnovativewood.com, who cut out the cutting boards from maple. They did a great job. Once cut they brought the cutting boards to us, and we engraved them with the CO2 laser.
Fiber Laser Engraved Aluminum Electronics Box
Lucid Scientific came to us needing several pieces of scientific equipment engraved with their name and serial numbers. These aluminum boxes engraved beautifully using the Fiber laser. Not only did it engrave through the black paint, but it's also permanently etched into the aluminum. The resulting etching was very nice.
Evereman laser cut stencils from baltic birch
Evereman artist stopped by the shop to laser cut some Evereman stencils from 1/8in Baltic Birch. H will be using these to make the rewards for the recent Kickstarter "Evereman Road Show". We used the CO2 laser to cut the stencils. Living in Atlanta, Evereman has been a staple of the local art scene, and it was great to meet the creator. The equipment in my shop gave him lots of other ideas. We cut some 2" pieces of stainless, and used the Fiber laser to etch Evereman on them.
